SCAN 61 Manuale del Proprietario

SCAN 60 and 61 INSTRUCTIONS FOR INSTALLATION AND USE Tested &Listed byBeavertonO regon U SAOMNI-Test Laboratories, In c. Save th

10 Alcove Installation Requirements: Whenever the stove is placed in a location where the ceiling height is less than 7’ tall, it is considered

11 Mobile Home Installation: US only In addition to standard installation the following requirements are mandatory for installation in a mobile

12 Outside air requirements Required for mobile home and in certain localities (Check with building officials) Outside air must not be drawn fr

13 Chimney Installation: Do not connect this unit to a chimney flue serving another appliance. Do not connect to any air distribution duct or s

14 Chimney Connection The chimney connector is ether a single or double walled pipe, depending on the type of installation, used to connect the s

15 Rear Vent Installation For venting into a masonry or a back standing steel chimney through the top vent the top horizontal portion of a single

16 Combustible Wall Chimney Connector Pass-Throughs. Method A. 12” (304.8 mm) Clearance to Combustib

17 NOTES: 1. Connectors to a masonry chimney, excepting method B, shall extend in one continuous section through the wall pass-through system an

18 3. INSTRUCTIONS FOR USE Ash Drawer The ash drawer located behind the fuel door is designed to make cleaning easier by containing the ashes in

19 Ceramic Packing Cord These stoves are equipped with a ceramic packing cord to ensure the tightness of the doors and the glasses. This packing

2 Table of Contents: 1. INTRODUCTION...

20 4. OPERATION WARNING: DO NOT USE GASOLINE, LIGHTER FLUID, KEROSENE OTHER FLAMMABLE LIQUIDS TO START OR FRESHEN A FIRE IN THE STOVE KEEP ALL

21 5. MAINTENANCE Ash Disposal and Removal CAUTION: Be sure the fire is out and the stove is cold before removing ashes! Be careful when you e

22 Removing Baffle for Cleaning. Be sure the fire is out and the stove is cold before removing baffle plate. Be cautions with handling the plat

23 Slide the air tube collar (pos.2) to the left, swing the air tube (pos.1) down and remove it. Replacement Part List SCAN 60 and

24 Door Glass A commercial glass cleaner designed for stoves is recommended for cleaning the glass. The glass can also be cleaned as follows: Dip

25 6. TROUBLESHOOTING Smoke: - Insufficient chimney draught! - Check if the chimney has the right dimension. - Check if the smoke pipe or chimne

26 7. WARRANTY CONDITIONS FOR SCAN WOOD BURNING PRODUCTS All SCAN wood stoves; inserts and fireplaces are subject to a strict quality control, b

27 8. EPA Sticker

3 We welcome you as a new owner of a SCAN wood-burning stove. In purchasing a SCAN stove you have joined the growing ranks of concerned individua

4 SAFETY PRECAUTIONS USE A METAL CONTAINER WITH A TIGHT FITTING LID TO DISPOSE OF ASHES. NEVER USE GASOLINE, GASOLINE-TYPE LANTERN FUEL, KEROSE

5 2. INSTALLATION Precaution If your SCAN stove is not properly installed, operated and maintained, a house fire may result. For your safety, f

6 NOTE: The clearances expressed in inches are those approved for installation in the United States. The clearances in expressed in millimeters a

7 Corner installation Floor pad at Corner Installation Model Floor protection A B C D Scan 60 USA 16” 7,5” 73,8” 104,5”Scan 60 Canada

8 Combustible Wall Clearance for Top Vent Installation If the stove is to be placed at side and back walls of combustible materials the followin

9 Combustible Wall Clearance for Rear Vent Installation If the stove is to be placed at side and back walls of combustible materials the followi